SHUNSEN INDUSTRIES CORPORATIONAdd To Favorites SHUNSEN INDUSTRIES CORPORATIONHome Page EnglishEnglish DeutschDeutsch españolespañol
SHUNSEN INDUSTRIES CORPORATION

quartz countertopsHome > quartz countertops

Quartz stone countertop processing and installation

1. Connection port
In order to avoid cracking of the board and to obtain the best processing results, the choice of the connection part must consider the following factors:
● The connection port should avoid the position of the stove or basin. It should not be docked at 45o at the corner. It should not be docked at the hole of the basin (distance not less than 80mm).
● The position of the basin is generally centered on the length of the cabinet of the cabinet; the position of the stove is generally taken by the hood.

2. Corner
In the L-shaped and U-shaped cabinets, the table top should be spliced from two or more plates, and the splicing position is selected in the corner. It is not possible to use a fabricated integral solid sheet because the L-shaped solid sheet is easily broken by thermal expansion and contraction or mechanical stress.

3. Opening and grooving
●Opening holes should be selected according to the measurement drawings to open holes in the factory to reduce the opening of the site; select the rounded holes to have the lowest cracking rate.
● If the distance between the grooved part and the table joint is less than 150mm, the area needs to be reinforced with wooden strips or artificial stone strips.
● It is forbidden to cut the inner corner into a right angle by cross cutting; when cutting, please use the cold water tool to avoid cracks.
● There should be a gap of 3-5MM around the hole of the pot, so as to avoid cracking due to the small hole being squeezed, and at the same time, it is necessary to expand the processing.

4. End face polishing
Polishing and polishing on the table surface must be the same color as other parts, and perform uniform horizontal polishing. When polishing, use cold water tools to avoid the plate being broken due to heat. It is strictly forbidden to manually polish the surface of quartz stone.

5. Levelness
The floor cabinet must be level, the upper and lower errors are less than 1.5MM, and the full pad must be cushioned to ensure the same level and no deformation. There should be no overhead between the countertop and the cabinet. If there is no cabinet, it must be supported in the overhead; the overall cabinet level requirements: the absolute value of two adjacent points is ≤0.5mm, and the overall absolute value is ≤3 mm.

6. Quartz stone countertop maintenance
● Do not place the high temperature or hot pot directly or permanently on the countertop.
● In operation, try to avoid scratching the countertop with sharp objects.
● Keep the table top clean. Do not soak or accumulate the table for a long time, keep the table clean and dry.
● Try to avoid touching relevant corrosive chemicals on the countertop in daily life. If you accidentally contact with it, immediately rinse the surface with plenty of soapy water or consult relevant professionals.

Communicate With Supplier